Skip to content
and found 5974 items
Ask an Expert
On me old kr1b2Like new ie chain guard rear no plate plastic thingieAnd mudguard oh their all black in colour ? Any help would be tops thanks the gungos
hello i was out riding yesterday on my bike, it cut out a couple of times then out of the blue completely stopped dead, the lights horn and other electrics all work but when you try to start her up nothing the starter don't turn, it's a 2000 hornet, also I tried a quick bump start and that didn't work
Anyone have a spare / know where one exists for a Daytona 955 on an 01 plate? Im tearing my hair out trying to get hold of one. Cheers
Hi all just signed up to the forums been a reader for a while now. Ride a 2005 ZX6 I'm planning to do a brake service soon to change the pads and clean all the crud out from winter.I've got most of the bits together - new pads, brake cleaner, torque wrench, brake fluid/bleed kit, but I just wanted to check if I should I be applying any sort of copper grease etc to the calliper bolts and brake pad bolts or will this throw the torque settings off.And the final thing was I wasn't sure what ...
Honda cbf600sa 2008 When headlamp is on dip there is only one side (nearside) is lit. Is this correct Have attached photos on dip and full beam
I haven't been able to ride my bike recently so as the weather was nice I took it off the trickle charger, checked tyre pressures etc, fired it up (eventually it took a while to start) and rode it on News years Eve.I stopped after 30 miles filled it up with Tesco fuel and carried on.It was going really well for forty miles or so and I was really enjoying being a biker again until I was changing down slowing up for a roundabout when it stalled (and I went sideways eek). It did restart after I pulled the clutch ...
My idle on Derbi senda x-treme 72cc 2-stroke with a dellorto carb 21 is too high (2000-2500rpm) and it doesnt fall. Theres not a problem with the throttle cable, there are no air leaks on the vacuums and the idle screws are adjusted fine. Also the carb is clean.What could the problem be? When i put 1st gear in theres a hit on the gearbox since the rpms are high and it will destroy it. Sometimes when i put 1st gear the engine stops after the hit.Please i need an answer fast because i am going to sell it in 3 days ...
I am going to buy a DID cain can anyone recommend a chain riviter other than the expensive km500 DID tool.I am a little dubious of the cheaper versions and would like some advice on buying a cheaper non DID tool. Do they work is the simple question or are they as some reviews suggest a waste of money. regards vic
Can some one help me,I have a Chinese lexmoto ht125-8 that my wife bought me for my birthday, it needs some work doing, I've done an oil change and cleaned the carb and changed the plugs now when I start it up the ideal speed is around 6000 rpm what do I do.It's probably a simpl answer but its my first bike and I'm following a Haynes manual.Any advice please email:ianconnor111@gmail.comCheers
Hi, help needed... Does anyone have fitting instructions for a translogic 3 quickshifter for an 04 R1 (5vy) or experience fitting one with gilles rearsets? Cheers dean
Save money by comparing quotes. It's quick and easy
Compare and buy 100s of bargain priced products for you and your bike
