Skip to content
and found 153 items
Ask an Expert
Picturehttp://i43.tinypic.com/9uu73c.jpgOn my zx6r when i serviced the brakes today i noticed on the rear caliper, there is a round plastic thing that sits inside the piston [outside touching the back of the pad]. But on the front pistons they're hollowed out and the pad just sits on the rim of the piston.I was just intrigued as to why that is and what the purpose of this plastic thing on the rear caliper isThanks
Hi, Bike is honda cmx250c, prob.wont tick over without choke on about an 1/4. when i try to get rid of the choke it revs higher then cuts out tryed to adjust tickover before cut out but just revs higher and cuts out , at this point engine is warm but wont restart without choke, when i open throttle it missfires in one cylinder. any ideas?....Conda
Thought of a new thread of ways to improve your bike without spending more than 30 pounds.Start with an oil change for example.With money being tight after numerous relacements i thought it could be a good time to compile some sort of improvement data base on a budget.
I just recently replaced my panels on my bike and had to change the indicators from one panel to the other. They now are having issues. I can operate the rhs indicator but not the left. This is also greeted by a buzzing on the rhs operation and a perm on position for the Lhs. Please help a new rider! Would prefer to learn how to do it myself than get someone else to fix it!
Hitrying to find a speedo drive for my 02 italjet millennium. I have tried italjet uk and other suppliers with no luck, so I am asking if anyone knows where I can find one or if their is a compatable one from another bikecheers
I am running a kawasaki ER6n - fully stock - would changing my air filter to a K&N or pipercross ake much difference to performance? would i need to change anything else? e.g fuelling??
I've just had the front wheel of my blackbird powder coated. When I tried to bolt on the disks, the threads stripped. I was using a torque wrench and they stripped at 10NM, the recommended torque is 20NM. As the wheel was goosed, I tried all 12 and they all stripped at or below 10NM. I've bought a second hand replacement wheel but don't want to repeat the process until know the cause. Any ideas?
I dont know too much about engine performance. I'm looking to buy a 600(ish) bike to last me two years, but heard that restrictor kit's can cause certain engines to perform badly, even degrade. When looking to buy, is there anything I should completely avoid if im wanting to restrict to 47hp? Thanks for reading. :DP.S - Sorry if im spouting total rubbish
Hi allJust changed the sparks on my 2005 zx6r, think theyre the originals having done 17k miles ..http://i43.tinypic.com/j5ee76.jpgJust wanted to check if they look as you'd expect - i noticed they all have some black oil or fuel muck on the threads, although the first [left side] plug had noticably less as well as a darkened patch further down on the plug is that a warning sign of anythingThanks for any help
hi,got an 05 z750 ,want to put z1000 exhausts on ,(pipe on either side ) can any body help .cheers steve
Save money by comparing quotes. It's quick and easy
Compare and buy 100s of bargain priced products for you and your bike
