Skip to content

Ask an Expert gpz 500 wont start Technical

You are in... Forums > Ask an Expert > Technical > gpz 500 wont start

Got something to say?

Got something to say?

Go to most recent reply

theklrnut

Joined:

May 12

Posts: 5

theklrnut says:

gpz 500 wont start

hi guys ive recently restored a gpz 500 that lay in a garage for 4yrs the tank was rusty inside had bike running with tank off putting petrol in to fuel pipe ran ok a bit spluttery dying when revved as there had been fuel left in bike stripped carbs cleaned jets and reassembled bike was stipped engine frame painted swinginarm removed welded resprayed tank and plastics resprayed wheels etc as this took a few months over winter bike now rebuilt but wont start tank cleaned out and inline filter put in fuel getting to carbs both plugs sparking tried with tank on and running fuel straight into main fuel line now and again a loud backfire tried pouring fuel down bores heating plugs brand new battery its driving me crazy any info much appreciated thanks guys:upset:

Reply to this Topic  
  • Posted 3 years ago (11 May 2012 23:51)

Post a message in Technical

Fields marked with an asterisk * are required

   

Please note. You cannot submit more than 4000 characters as a message.

Upload image(s) from your computer (up to 3 images)

  1.  
  2.  
  3.  

Terms of use

Use of our community areas and forums is subject to important terms of use. By joining our community and using the features you agree to be bound by these terms. See terms of use below. 

Cancel
smidget

Joined:

Nov 07

Posts: 2432

smidget says:

Hi

If you stripped the engine then check the ignition timing, also check that you have the correct HT going to the correct cylinder.

I am not sure if this bike runs with a lost spark set-up.

More info would help in a better diagnosis 

Reply to this Topic
kcmc

Joined:

Jan 08

Posts: 7745

kcmc says:

Kawasaki GPZ 500S Year?

Hi thekirnut

Quick one,if your sure everything you have done is correct?then try some easy start and a new set of plugs(i know you have new plugs)sounds like you may have flooded the engine and killed the new plugs?.Try taking the plugs out,spray some easy start down each plug hole and turn the engine over on the starter(this should dry things out and help with combustion).replace with new plugs turn petrol on,no choke yet,turn the engine over on the starter while spraying short bursts of easy start into the air box(top off and filter removed)if the bike starts try keeping it going until warm,only use the choke if it wont stay running with out it.Good Luck

KCMC:tongue:   

Reply to this Topic
theklrnut

Joined:

May 12

Posts: 5

theklrnut says:

gpz 500

thanks for ur help try again tmoro weather permitting:biggrin:

Reply to this Topic

Page

Compare Insurance

Save money by comparing quotes. It's quick and easy

Motorcycles for sale

 

It's only £13.99 to advertise your motorcycle on MCN

Sell your Motorcycle

Motorcycle pricing tool

New! Find used bike prices